Gorman-Rupp Pumps UNIT 608-A 1347755 thru 1395613 - Manual (Page 8)

UNIT SERIES OM−01238
PAGE B − 1 INSTALLATION
INSTALLATION − SECTION B
Review all SAFETY information in Section A.
Since pump installations are seldom identical, this
section offers only general recommendations and
practices required to inspect, position, and ar-
range the pump and piping.
Pump Dimensions
See Figure 1 for the approximate physical dimen-
sions of this pump.
OUTLINE DRAWING
Figure 1. Pump Model UNIT 608−A
PREINSTALLATION INSPECTION
The pump assembly was inspected and tested be-
fore shipment from the factory. Before installation,
inspect the unit for damage which may have oc-
curred during shipment. Check as follows:
a. Inspect the pump, reel assembly, hose and
motor for cracks, dents, damaged threads,
and other obvious damage.
b. Check for and tighten loose attaching hard-
ware. Since gaskets tend to shrink after dry-
ing, check for loose hardware at mating sur-
faces.
c. Carefully read all tags, decals, and markings
on the unit, and perform all duties indicated.
d. If the pump and motor have been stored for
more than 12 months, some of the compo-
nents or lubricants may have exceeded their
maximum shelf life. These must be inspected
or replaced to ensure maximum pump serv-
ice.
e. Check to ensure the following standard
equipment items are included with the pump
assembly:
S Detachable reel assembly.
S 42 foot long hydrocarbon-resistant hose.
S 8 foot long connector hose.
S 15 foot long suction and discharge hose.
S 12 foot long stainless steel standpipe.
S 10 foot long ground wire.
If the maximum shelf life has been exceeded, or if
anything appears to be abnormal, contact your