Gorman-Rupp Pumps 16D60-F3L 1270259 thru 1318306 - Manual (Page 31)

10 SERIES OM--05534
MAINTENANCE & REPAIR PAGE E -- 10
Disengage the nuts (66) and remove the suction
flange, gasket (67) and check valve as an assem-
bly.
Inspect the check valve components for excessive
wear or damage. If disassembly is required, re-
move the hardware (59 and 60) and separate the
valve weights (61 and 63) from the check valve
gasket (62).
Separating Intermediate and Drive Assembly
From Engine
(Figure 4)
Further disassembly requires separating the pump
end and drive assembly from the engine. Install a
standard 5/8-11 UNC lifting eye in the tapped hole
in the top of the pump casing.
Be sure to screw the
eye into the casing until fully engaged. Support the
pump using a suitable hoist and the lifting eye.
Do not attempt to lift the complete pump
unit using the lifting eye. It is designed
to facilitate removal or installation of in-
dividual components only. Additional
weight may result in damage to the
pump or failure of the eye bolt.
Disengage the hardware (6 and 7) securing the
drive flange to the engine bellhousing, and remove
the guards (29, Figure 3). Separate the pump end
and drive assembly from the engine by pulling the
pump end straight away from the engine.
As the assemblies separate, the flexible portion of
the coupling assembly (3) will remain on the shaft.
To remove the coupling from the shaft, unscrew the
two allen head setscrews from the bushing (2).
Screw one of the setscrews into the puller hole on
the circumference of the bushing. As the coupling
and bushing separate, remove the bushing, and
slide the coupling off the shaft. Remove the shaft
key (24, Figure 3).
It is not necessary to remove the outer ring of the
coupling from the engine flywheel unless the cou-
pling must be replaced. To remove the ring, disen-
gage the hardware (4 and 5) securing it to the fly-
wheel.
Remove any leveling shims used under the casing
mounting feet. Tie and tag the shims for ease of
reassembly.
Move the pump end to a clean, well equipped shop
area for further disassembly.
Loosening Impeller
(Figure 3)
Before attempting to loosen the impeller, remove
the seal cavity drain plug (35) and drain the lubri-
cant. This will prevent the oil from escaping as the
impeller is removed. Clean and reinstall the drain
plug.
With the pump end separated from the engine and
the back cover assembly (53) removed, wedge a
block of wood between the vanes of the impeller
and the pump casing to prevent rotation.
If removed, install the shaft key (24) in the shaft
keyway. Install a lathe dog on the drive end of the
shaft (25) with the “V” notch positioned over the
shaft key.
With the impeller rotation still blocked, see Figure 5
and use a long piece of heavy bar stock to pry
against the arm of the lathe dog in a counterclock-
wise direction (when facing the drive end of the
shaft).
Use caution not to damage the shaft or key-
way. When the impeller breaks loose, remove the
lathe dog, key and wood block.
NOTE
Do not remove the impeller until the pump casing
has been removed.