Gorman-Rupp Pumps 14D1-GX390 1325668 and up - Manual (Page 25)

OM−04529 10 SERIES
MAINTENANCE & REPAIR PAGE E − 7
Inspect the wear plate and, if replacement is re-
quired, remove the hardware (16 and 17) securing
it to the back cover.
Pump Casing Removal
(Figure 2)
To service the impeller or seal assembly, discon-
nect the discharge piping and remove the dis-
charge elbow (2, Figure 1) to provide clearance.
See Figure 1 and remove the hardware (13, 14 and
15) securing the pump casing to the rollover base
(4).
Support the pump casing (1) using a suitable hoist
and sling, and remove the nuts (14) securing the
pump casing to the intermediate (12). Separate the
parts by pulling the casing straight away from the
intermediate. If shims have been used under the
mounting feet to level the pump casing, tie and tag
these shims for ease of reassembly.
Remove the casing gasket set (8). Record the
thickness of the gaskets for future reference. Clean
the mating surfaces of the intermediate and pump
casing.
Impeller Removal
(Figure 2)
To loosen the impeller (2), tap the vanes of the im-
peller in a counterclockwise direction (when facing
the impeller) with a block of wood or a soft-faced
mallet. Unscrew the impeller and replace it if
cracked or badly worn. Use caution when remov-
ing the impeller; tension on the seal spring will be
released as the impeller is unscrewed.
Slide the impeller adjusting shims (36) off the im-
peller shaft. Tie and tag the shims or measure and
record their thickness for ease of reassembly.
Seal Removal and Disassembly
(Figures 2 and 4)
Remove the spring centering washer and seal
spring. Slide the shaft sleeve (37) and rotating por-
tion of the seal off the shaft as an assembly. Lubri-
cate the sleeve adjacent to the seal and work oil up
under the rubber bellows. Slide the rotating portion
of the seal off the shaft sleeve.
Remove the hardware (10 and 11) and carefully
slide the intermediate (12) and stationary portion of
the seal off the shaft as a unit. Use a suitably sized
dowel to press the stationary element out of the in-
termediate from the back side.
NOTE
The seal assembly may be removed without com-
pletely disassembling the pump by using a pair of
stiff wires with hooked ends to pull the seal station-
ary seat out of the intermediate.
If no further disassembly is required, see Seal
Reassembly and Installation.
Seal Reassembly and Installation
(Figures 2 and 4)
Clean the seal cavity and shaft with a cloth soaked
in fresh cleaning solvent.
Most cleaning solvents are toxic and
flammable. Use them only in a well ven-
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain-
ers.
The seal is not normally reused because wear pat-
terns on the finished faces cannot be realigned
during reassembly. This could result in premature
failure. If necessary to reuse an old seal in an emer-
gency, carefully wash all metallic parts in fresh
cleaning solvent and allow to dry thoroughly.
Handle the seal parts with extreme care to prevent
damage. Be careful not to contaminate precision
finished faces; even fingerprints on the faces can
shorten seal life. If necessary, clean the faces with a
non-oil based solvent and a clean, lint-free tissue.
Wipe lightly in a concentric pattern to avoid
scratching the faces.
Inspect the seal components for wear, scoring,
grooves, and other damage that might cause leak-