Gorman-Rupp Pumps 13A65-B 776101 and up - Manual (Page 7)

10 SERIES OM-02146
PAGE A - 2 SAFETY
Do not operate the pump without the
shields and/or guards in place over the
drive shaft, belts, and/or couplings, or
other rotating parts. Exposed rotating
parts can catch clothing, fingers, or
tools, causing severe injury to person­
nel.
Do not operate the pump against a
closed discharge valve for long periods
of time. If operated against a closed dis­
charge valve, pump components will
deteriorate, and the liquid could come
to a boil, build pressure, and cause the
pump casing to rupture or explode.
Overheated pumps can cause severe
burns and injuries. If overheating of the
pump occurs:
1. Stop the pump immediately.
2. Ventilate the area.
3. Allow the pump to completely cool.
4. Check the temperature before
opening any covers, plates,
gauges, or plugs.
5. Vent the pump slowly and cau­
tiously.
6. Refer to instructions in this manual
before restarting the pump.
Do not remove plates, covers, gauges,
pipe plugs, or fittings from an over­
heated pump. Vapor pressure within the
pump can cause parts being disen­
gaged to be ejected with great force. Al­
low the pump to completely cool before
servicing.
This pump is designed to handle materi­
als which could cause illness or injury
through direct exposure or emitted
fumes. Wear adequate protective cloth­
ing when working on the pump or pip­
ing.
Never run this pump backwards. Be cer­
tain that rotation is correct before fully
engaging the pump.
Pumps and related equipment must be in­
stalled and operated according to all na­
tional, local and industry standards.