Gorman-Rupp Pumps 82H52-B 1325648 and up - Manual (Page 30)

OM−00836 80 SERIES
MAINTENANCE & REPAIR PAGE E − 10
Suction Check Valve Installation
Inspect components of the check valve assembly
(41) and replace as required. If separated at disas-
sembly, assemble the check valve weights (43 and
44) to the check valve gasket (42) with the hard-
ware (45 and 46).
Position the check valve assembly in the suction
port with the large weight (43) facing toward the in-
side of the pump casing. Install the suction flange
(40) and secure with the nuts (39). Check the oper-
ation of the check valve to ensure proper seating
and free movement.
Final Pump Assembly
Be sure the pump and power source are securely
mounted to the base. Reconnect the power source
to the pump.
Install the suction and discharge lines and open all
valves. Make certain that all piping connections are
tight, properly supported and secure.
If a lifting eye was used to move the pump casing,
be sure to remove the lifting eye from the pump
casing.
Be sure the pump and power source have been
properly lubricated, see LUBRICATION.
Fill the pump casing with clean liquid. Reinstall the
fill plug (47) and tighten it.
Refer to OPERATION, Section C, before putting
the pump back into service.
LUBRICATION
Seal Assembly
The seal assembly is lubricated by the medium be-
ing pumped, and no additional lubrication is re-
quired.
Bearings
The pedestal was fully lubricated when shipped
from the factory. Check the oil level regularly
through the sight gauge (21) and maintain it at the
middle of the gauge. When lubrication is required,
add SAE No. 30 non-detergent oil through the hole
for the air vent (9). Do not over-lubricate. Over-lu-
brication can cause the bearings to over-heat, re-
sulting in premature bearing failure.
NOTE
The white reflector in the sight gauge must be posi-
tioned horizontally to provide proper drainage.
Under normal conditions, change the oil each
5000 hours or once each year, more frequently if
the pump is operated continuously or installed in
an environment with rapid temperature change.
Monitor the condition of the bearing lubri-
cant regularly for evidence of rust or mois-
ture condensation. This is especially im-
portant in areas where variable hot and
cold temperatures are common.
For cold weather operation, consult the factory or a
lubricant supplier for the recommended grade of
oil.
Power Source
Consult the literature supplied with the power
source, or contact your local power source repre-
sentative.