Gorman-Rupp Pumps 06B52-B 1332442 and up - Manual (Page 27)

0 SERIES OM-01229
MAINTENANCE & REPAIR PAGE E - 8
Most cleaning solvents are toxic and
flammable. Use them only in a well ven­
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain­
ers.
The seal is not normally reused because wear pat­
terns on the finished faces cannot be realigned
during reassembly. This could result in premature
failure. If necessary to reuse an old seal in an emer­
gency, carefully wash all metallic parts in fresh
cleaning solvent and allow to dry thoroughly.
Handle the seal parts with extreme care to prevent
damage. Be careful not to contaminate precision
finished faces; even fingerprints on the faces can
shorten seal life. If necessary, clean the faces with a
non‐oil based solvent and a clean, lint‐free tissue.
Wipe lightly in a concentric pattern to avoid
scratching the faces.
Inspect the seal components for wear, scoring,
grooves, and other damage that might cause leak­
age. If any components are worn, replace the com­
plete seal; never mix old and new seal parts.
If a replacement seal is being used, remove it from
the container and inspect the precision finished
faces to ensure that they are free of any foreign
matter. Discard the spring centering washer in­
cluded with the seal. It is not used in this applica­
tion.
To ease installation of the seal, lubricate the bel­
lows and O‐rings with water or a very small
amount of light lubricating oil, and apply a drop of
light lubricating oil on the finished faces. Assemble
the seal as follows, (see Figure 3).
IMPELLER
SHAFT
SEAL
PLATE
ROTATING
ELEMENT
RETAINER
SPRING
IMPELLER
ADJUSTING
SHIMS
IMPELLER
BELLOWS
SHAFT
SLEEVE
O‐RING
STATIONARY
SEAT
Figure 3. 25285-856 Seal Assembly
This seal is not designed for operation at
temperatures above 160
_F (71_C). Do not
use at higher operating temperatures.
Lay the seal plate (9) on a flat surface with the im­
peller side facing up. If the wear ring (38) was re­