Gorman-Rupp Pumps 04B3-B 806819 and up - Manual (Page 25)

OM-01214 0 SERIES
MAINTENANCE & REPAIR PAGE E - 5
separate the pump casing and gasket (9) from the
seal plate and pedestal.
Tie and tag any leveling shims used under the cas­
ing feet to ease reassembly.
Inspect the wear ring (44) for excessive wear or
scoring. The wear ring is secured in the pump cas­
ing by a press fit. If replacement is required, use a
small bit to drill two holes through the ring horizon­
tally, 180
_ apart. Use a saw or chisel to complete
the cuts through the ring, and remove it from the
pump casing. Use caution not to damage the
pump casing bore when removing the wear ring.
Use caution not to damage the pump cas­
ing bore when removing the wear ring.
Impeller Removal
Immobilize the impeller by inserting a bar between
the impeller vanes, being careful not to damage
the vanes. Disengage the hardware (41, 42 and
43). Remove the bar from the impeller.
Install 3/8-16 UNC by 4‐inch long capscrews in
the tapped holes in the impeller. Use the caps­
crews and a suitable puller to remove the impeller
from the shaft. Use caution when removing the im­
peller; tension on the seal spring will be released as
the impeller is removed. Retain the impeller key
(58).
Remove the impeller adjusting shims (12). Tie and
tag the shims or measure and record their thick­
ness for ease of reassembly.
Seal Removal and Disassembly
(Figures 1 and 3)
Remove the seal spring. Slide the shaft sleeve (40)
and rotating portion of the seal off the shaft as a
unit.
Apply oil to the sleeve and work it up under the rub­
ber bellows. Slide the rotating portion of the seal off
the shaft sleeve.
Use caution not to damage the seal plate
bore when removing the wear ring.
Remove the machine screws (11) and slide the
seal plate and stationary element off the impeller
shaft as a unit. Press the stationary seal element
and O‐ring out of the seal plate from the back side.
Inspect the wear ring (59) for excessive wear or
damage. The wear ring is secured in the seal plate
by a press fit. If replacement is required, use a
small bit to drill three to four holes through the ring
horizontally, equal distances apart. Use a saw or
chisel to complete the cuts through the ring, and
remove it from the seal plate. Use caution not to
damage the seal plate bore when removing the
wear ring.
Shaft And Bearing Removal And Disassembly
When the pump is properly operated and main­
tained, the pedestal should not require disassem­
bly. Disassemble the shaft and bearings only
when there is evidence of wear or damage.
Shaft and bearing disassembly in the field
is not recommended. These operations
should be performed only in a properly
equipped shop by qualified personnel.
Remove the pedestal drain plug (33) and drain the
lubricant. Clean and reinstall the drain plug.
Remove the slinger ring (36). Remove the caps­
crews (13) and slide the assembled bearing cap
(35) and oil seal (14) off the shaft. Remove the bear­
ing cap gasket (34). Press the oil seal from the
bearing cap.
Remove the shaft key (25). Remove the capscrews
(23) and slide the assembled bearing cap (22) and
oil seal (24) off the shaft. Remove the bearing cap
gasket (21). Press the oil seal from the bearing cap.
Remove the bearing shim set (29); tie and tag the
shims, or measure and record their thickness for
ease of reassembly.