Gorman-Rupp Pumps 03H1-GX390 1178614 and up - Manual (Page 28)

0 SERIES OM-04728
MAINTENANCE & REPAIR PAGE E - 10
Pump Installation
(Figure 1)
Secure the pump (1) to the base (4) with the pre­
viously removed hardware. Be sure to install any
leveling shims used under the casing mounting
feet.
Install the suction and discharge lines and open all
valves. Make certain that all piping connections are
tight, properly supported and secure.
Be sure the pump and engine have been properly
lubricated (see LUBRICATION).
(Figure 2)
Remove the fill plug assembly (6) and fill the pump
casing with clean liquid. Reinstall the fill plug as­
sembly and tighten it.
Refer to OPERATION, Section C, before putting
the pump back into service.
LUBRICATION
Seal Assembly
(Figure 2)
The seal assembly is lubricated by the medium be­
ing pumped and no additional lubrication is re­
quired.
Engine
(Figure 1)
Consult the literature supplied with the engine, or
contact your local engine representative.