Gorman-Rupp Pumps SE1 1/2B3-E.33 12V 1483930 and up - Manual (Page 23)

SE SERIES OM−06490
MAINTENANCE & REPAIR PAGE E − 9
Position the motor cover in the casing tube with the
studs (1B) through the holes in the motor cover.
Install the hardware (27 and 28) and tighten the
nuts (27) in an alternating pattern until the motor
cover is fully seated in the casing tube. Use caution
not to cut or pinch the casing tube O-ring.
Slide the sealing rings (26) down the cable leads
and into the bores in the motor cover. Slide the
spacers (25) down the leads onto the sealing rings.
Screw the gland nuts (24) into the motor cover to
seal the cables.
Secure the cable leads to the motor cover with the
cable clamp (23) and hardware (21 and 22).
If removed, reinstall the lifting handle (20) and se-
cure it with the jam nut (19).
Proceed with PUMP END REASSEMBLY.