Elmo Rietschle R-WPB - Manual (Page 12)

Rietschle Thomas GmbH + Co. KG page 12 / 23
Plates and labels on base units and compact units:
Base unit, compact unit and sound enclosure plate
The following cardboard label is hung on the suction
sensor, pressure gauge or blower itself (if delivered
separately):
TRANSPORTED
WITHOUT OIL
The correct direction of rotation is indicated by the
following arrow placed on the blower cover (near the shaft)
and the belt guard:
In accordance with the EN 1012 Standard, the following
labels are placed on the blower and blower sets (according
to their types):
- C1 Order: Read the Directions for Use
- C2 Required activity: Order to wear ear protectors
- C7 Warning: High temperature risk
- C19 Oil filling
- C 21 Suspension point
- Plate - warning
- “ATTENTION“ red plate.
On the suction silencer or the acoustic enclosure.
- “ATTENTION: CUTTING EDGE“ plate.
On the sub frame of the blower set, below the pendulous
motor frame.
Blower operation failures can be divided into two main
categories:
- Mechanical failures (bearings, toothed wheels, rotors,
etc.); and
- Electrical failures (faulty drive, wiring, contactors, fuses,
etc.).
If any electric failure occurs, you must notify the specialists
authorized to repair such failures.
If you are unsure about the correctness of your procedure,
call the Rietschle Thomas service department.
5.7 P
LATES
AND LABELS
USED ON BASE
UNITS AND
COMPACT UNITS
5.8
I
NSTRUCTIONS
FOR TRACING
SIMPLE FAILURES