AAEON ETX-945GSE - Manual (Page 5)

E T X C P U M o d u l e E T X - 9 4 5 G S E
iv
Application Notes
1. After installing drivers in AT power mode under Windows
®
XP
operation, there is no message: “It is now safe to turn off your
computer” during the procedure of turn-off.
2. Hyper threading technology only supports ATX mode rather than
AT mode.
3. If you are going to use the add-on PCI Video Card instead of the
onboard Intel
®
945GSE VGA function, you have to uninstall the
onboard Intel
®
VGA driver before installing the driver of add-on
PCI Video Card.
4. While installing OS into SATA HDD, please do not attach any
IDE HDD during installation. If you need one IDE HDD as
storage device, please attach IDE HDD after finishing the
installation.
5. If using LCD by 800x480 pixel,
A. Please set LCD as primary
B. Operation procedure to run dual display or extended display
under Window
®
XP:
a. Please use control panel -> display device-> adjust
b. Use right button of mouse to select
6. Under DOS mode, if setting simultaneous displays
A. 24-bit LVDS LCD (from Chrontel 7308) + VGA: the screen
shrinks at any resolution.
B. 18-bit LVDS LCD + VGA: the screen shrinks at resolution
640x480.
7. DIO address is “200H.”
8. Module can run without RTC battery.
9. Two options to select AT/ATX power mode
Auto switch circuit
SMT jumper
10. SDVOCTL_CLK & SDVOCTL_DATA are connected to 945GSE;
SMBUS is connected to ICH7M; I2C bus is connected to
Winbond SIO.