AAEON AGD-310D - Manual (Page 43)

L C D D i s p l a y A G D - 3 1 0 D
4.2 Resistive Touchscreen Driver Installation
Hardware
Touch screen controllers must be configured for the driver prior to
installation. EETI typically ships controllers in a default setup that is
compatible with this driver. Controller requirements are:
Serial
Serial controllers must conform to these minimum requirements:
Baud rate: 9600 Baud
Data mat: SMARTSET
It is desirable for a full handshaking connection to be established
between the touch screen controller and the computer, but it is not
required. The controller will function with this driver in a "two-wire,"
Receive Data and Ground (RxD and Gnd) configuration. The
consequences of a two-wire connection are:
+ Automatic detection of the controllers on serial ports during setup
is not possible。
+ Controller information will not be registered in the Property Page
of the Control Panel。
USB
* USB controllers require no configuration prior to installation.
*EETI USB controllers are Human Interface Device (HID) compliant.
The Windows
®
XP and Windows
®
7 operating systems have native
Chapter 4 Driver Installation 4-5