ABUS TVIP41550 PIR network camera User Manual
Page 336
336
Syntax:
http://<servername>/cgi-bin/admin/ipfilter.cgi?
method=<value>&[start=<ipaddress>&end=<ipaddress>][&index=<value>]
[&return=<return page>]
PARAMETER
VALUE
DESCRIPTION
Method
addallow
Add a set of allow IP address range to server. Start and end
parameters must be specified. If the index parameter is
specified, it will try to add starting from index position.
adddeny
Add a set of deny IP address range to server. Start and end
parameters must be specified. If the index parameter is
specified, it will try to add starting from index position.
deleteallow
Remove a set of allow IP address range from server. If start and end
parameters are specified, it will try to remove the matched IP address.
If index is specified, it will try to remove the address from given index
position. [start, end] parameters
have higher priority then the [index] parameter.
deletedeny
Remove a set of deny IP address range from server. If start and end
parameters are specified, it will try to remove the matched IP address.
If index is specified, it will try to remove the address from given index
position. [start, end] parameters
have higher priority then the [index] parameter.
start
<ip address>
The start IP address to add or to delete.
end
<ip address>
The end IP address to add or to delete.
index
<value>
The start position to add or to delete.
return
<return page>
Redirect to the page <return page> after the parameter is assigned.
The <return page> can be a full URL path or relative path according to
the current path. If you omit this parameter,
it will redirect to an empty page.
UART HTTP tunnel channel (capability.nuart>0)
Note: This request requires operator privilege
Method: GET and POST