ABUS TVAC15000B User Manual
Page 22
22
English
10. Tips for troubleshooting
No. Question
Answer
1
What does pairing the
monitor and camera mean
and how does this work?
Pairing creates the exclusive, encrypted wireless connection
between the monitor and camera.
To connect a camera to the monitor, proceed as follows:
1. Connect the power supply units to the cameras and the
monitor.
2.
In the “Camera Setup -> Pairing” menu of the TFT monitor,
select a camera (1-4) and confirm the selection with OK.
The system counts down from 60 seconds.
3. During the 60 seconds, press the PAIRING button on the
camera cable until the green LINK LED on the front of the
camera starts flashing.
4. Once the connection is established, the LINK LED on the
camera is lit up continuously and the monitor switches to
live view.
Please note that connection can take up to 60 seconds.
2
What could be the reasons
why the monitor displays
“NO SIGNAL” instead of a
picture?
If you do not have a picture signal, please check the following:
1.
Is the camera connected to the power supply (does the
LED light up red)?
2.
Are the camera and monitor paired with each other?
3.
Is the camera within range of the monitor?
4.
Is the signal between the camera and monitor disrupted?
3
What could be the reasons
why the device does not
record?
If your device does not record, please check the following:
1.
Have you inserted an SD card?
2.
Is the SD card locked? (Lock/Unlock?)
3.
Have you formatted the SD card? It must be formatted
before it is first used.
4
What could be the reasons
why the device does not
record when there is
movement?
The “motion detection” function may be switched off. Please
go into
the “Recorder Setup / Motion Detection / ON/OFF”
menu and set the function to “ON”.
5
What should I do if, in night
mode, half of the image
shows nothing and remains
black?
The camera has an integrated infrared swivel filter which
ensures the camera switches to night mode when it is dark. If
part of the image is black, it is possible that the swivel filter has
got stuck mechanically. Tapping the camera lightly can solve
this problem.
6
Is a standby mode possible?
You can switch the device to an energy saving mode. If the
camera detects a movement during this time, the image is
automatically displayed.
7
Can the sound for the
motion detection be
adjusted?
Yes, in the menu item “Record Settings” you can turn off the
alarm tone. You will find this under “Alarm Period”.
8
Can more than one monitor
be used at the same time?
No, for technical reasons this is not possible because a
camera can only be paired directly with one monitor
(camera(s) and monitor form a pair).