Installation, Installing the monitor, Pairing the camera and the monitor – ABUS TVAC16000B User Manual
Page 11
9
English
6. Installation
6.1 Installing the monitor
1.
Connect the power supply unit to the monitor.
2.
Switch the device on. Press the power button for about 5 seconds.
Important:
Please note that if the monitor does NOT have an external power supply, it must be charged for at
least 8 hours prior to being used for the first time.
The batteries will provide power for approx. 1.5 hours.
Important:
The integrated battery allows you to use the LCD monitor flexibly.
If the battery symbol
lights up in red, then the batteries must be charged. Please note that
the battery must always be charged sufficiently so as to ensure loss-free recording.
6.2 Pairing the camera and the monitor
To connect a camera with the monitor, proceed as follows:
1.
Connect the camera and the monitor to the power supply.
2.
In the
monitor menu, select “Camera”, then “Pairing” and the required camera (1-4). The system counts
down from 60 seconds.
3.
Press the PAIRING button briefly on the camera cable during these 60 seconds.
4.
The LINK LED is lit up continuously once the connection is established.
Important:
Please note that the connection can take up to 60 seconds.