Aeromotive 11202 - A2000 CARBURETED FUEL PUMP - Manual (Page 4)

Thanks for purchasing another quality product designed, engineered and manufactured in
Kansas City, USA!
AEROMOTIVE, INC.
7805 Barton Street, Lenexa, KS 66214
913-647-7300 fax 913-647-7207
12. The Pump Bypass regulator is pre-set at 18 PSI at the factory. If pump pressures above 18 psi are
desired (as for limited duty such as drag racing applications) loosen the jam nut and turn the pump on.
You can achieve this with the engine on or off by turning the adjustment screw clockwise to increase
pressure, and counterclockwise to lower the pressure. When the desired pressure is obtained simply
re-tighten the jam nut.
13. Shut the engine off. Using suitable clips and other mounting hardware, secure the newly installed fuel
lines and electrical wires by attaching them to the vehicle chassis.
Test drive the vehicle to insure proper operation and re-check the fuel system for leaks. If any leaks are
found, immediately discontinue use of the vehicle and repair the leak(s)!