Alera Lighting SOLO - Suspended - Manual (Page 2)

© 2010 Alera Lighting, a division of Hubbell Lighting, Inc. Because of continuing product improvement programs, Alera Lighting reserves the right to change specifications
without notice. 701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Tech Support 864.678.1580 / Website www.aleralighting.com
Page 2/2 Rev. 01/19/10 CuRveS / SOLO SuSpended TId
SOLO SuSpended
Technical Installation data
Suspension Instructions:
1. Set bottom nut to desired fixture height.
2. Slide cable hanger into hanger slot.
3. Secure and tighten upper nut.
4. Push plunger down to adjust cable to proper
suspension. Cut excess cable.
5. For fine-tuning of fixture balance, slide knuckle
across yoke. Twist cable gripper to lock in place.
Connection Instructions:
1. Install first fixture of row with two hangers.
2. Insert aligners in end of fixture as shown.
3. Make electrical connection, engage aligners, and slide the
two housings together.
4. Bolt the fixtures together using screws and nuts provided.
Cable Gripper
Plunger
Yoke
Screw
Nut