Alpha Technologies FlexNet MPS48-12M - Technical Manual - Manual (Page 17)

17 021-514-B2-001, Rev. A
(back view)
4.0 Installation, continued
4.3 Enclosure Installation, Steel or Concrete Pole
To mount the MPS48-12M on concrete or steel poles, two user-supplied mounting straps
are required (straps must be stainless, galvanized or equivalent). Most codes require the
base of the enclosure to be located a minimum height from the ground. Always verify height
restrictions before proceeding.
Installation Procedure:
1. Position the bracket at the appropriate height with the tab facing up. Secure
to the pole with the pole straps.
Recommended Tools and Materials:
• #2 Phillips screwdriver
• Two pole straps sized to fi t pole
(straps must be stainless, galvanized or equivalent)
Tab
2. Affi x the four screw gaskets to the back of the enclosure, over
the bracket mounting holes.
The majority of poles are the property of the local utility. Before installing an enclosure, the location and method of
mounting must be approved by the utility.
ATTENTION: