Alpha Technologies CFR 5000, CFR 5000RM - Manual (Page 78)

5 Maintenance 72
Alpha Technologies
5.5 Configuring the Input/Output Voltage (Continued)
Output
Terminal
Block
Step 3: Reconfigure the Output Terminal Block
1 Find the output terminal block, which is mounted on the bottom panel between the
transformer and the rear panel.
1 2 3 4 1 2 3 4 1 2 3 4
120 VAC Output
Transformer This Way
208 VAC Output 240 VAC Output
120 N 120 N 120 N 208 240
To Output
Receptacles
To Output
Receptacles
Rear Panel This Way
2 If needed, configure the output terminal block to the output voltage you are using as
shown below.
3 Reattach all of the unit’s panels.
4 Turn on the unit (Section 3.1). Before turning on the loads, measure the output
voltage to make sure this procedure has been done correctly.
Voltage Reconfiguration Finished