Alpha Technologies EDSM - Manual (Page 17)

704-721-C0-004, Rev. D 17
Fig. 3-2, EDSM Details
3.0 Module Installation, continued
3.1 XMS2 Communication Module Removal Procedure, continued
7. Slide the inverter module out of the power supply.
8. Unscrew the captive mounting screws holding the existing comm module onto the
inverter module sheet metal.
9. Verify that the 2x9 pin jumper is in position, seated fully into the inverter module.
10. Align the XMS2 header on the EDSM with the 2x9 jumper and gently press into place.
11. Tighten the captive mounting screws into the inverter module.
Inverter Board
Connector
2x9 Jumper
Sheet Metal
EDSM
Connector
CaptiveMounting
Screw
AlphaBus
Connector
XMS2 Interface
Connector
OEM Embedded
Transponder Cable
Top View
Optional DT
Connector
Detail of XMS2
Interface Connector
AUX and Tamper
Connectors