Alpha Technologies AlphaNet IDH4 for XM3-HP Series - Quick Start Guide - Manual (Page 4)

4 746-257-B1-001 Rev. A (2/2014)
Installation / Replacement Procedure, continued
9. Reinstall the Inverter Module and tighten the two thumbscrews. Make front panel connections (tamper, temperature sensor,
battery sense, RF, etc.).
10. If not yet done, record the cable modem MAC address from the front of the unit and report it to the network manager for
network provisioning. For Dual IP applications, the CPE MAC address should also be recorded.
Fig. 4, The 18-pin Connector Fig. 5, Connecting the Transponder to the Inverter Module
7. Line up the 18-pin mating connectors on the IDH4 Series and the XM3-HP Inverter Module. Gently push the IDH4 Series
into the Inverter Module until the 18 pin mating connector is properly seated.
8. Fasten the IDH4 Series to the Inverter Module by tightening the two captive screws. It is recommended that the screws
be tightened alternately, a few turns at a time so the transponder aligns in parallel to the Inverter Module.
Captive Screws
Fig. 3, Captive Screw Locations