Alpha Technologies AlphaNet IDH4 for XM3-HP Series - Technical Manual - Manual (Page 88)

88 746-257-B5-001, Rev. A1 (11/2013)
The CPE Transponder IP can be assigned its IP, Subnet Mask and Gateway Addresses via a DHCP
server.
13.0 Dual IP Mode (Addendum), continued
13.3 Configuring Dual IP Mode
To switch the IDH4 Series transponder from Single to Dual IP mode the atiMgmtSnmpSnmpCPEAccess
parameter of the Alpha MIB will need to be enabled. The Dual IP enable setting can be set through
the DOCSIS Configuration file, the IDH4 Setup File (idhdoc04.cfg), the Provisioning Mode via the
Communications Web page or remotely using SNMP by setting the following Alpha MIB:
MIB Parameter Object ID Description Value
atiMgmtSnmpSnmpCPEAccess 1.3.6.1.4.1.926.1.3.1.3.6.0 Enables/Disables the
CPE Interface
1=Disabled (Single IP)
2=Enabled (Dual IP)
Table 13-2, Enabling Dual IP mode
Fig. 13-5, Dual IP Configuration Settings on the Communications Page of IDH4 Web Server
Fig. 13-6, Dual IP Parameters on the General Page of IDH4 Web Server