Figure 4, side bracket installation, Figure 5, lock bracket alignment and installation – Alpha Technologies UPE-3, UPE-6, UPE-M3, UPE-M6, PN, CE and FPE Series - Quick Start Guide User Manual
Page 2
Alpha Technologies reserves the right to make changes to the products and information contained in this document without notice.
Copyright © 2006 Alpha Technologies. All Rights Reserved. Alpha
®
is a registered trademark of Alpha Technologies. member of The Alpha Group™ is a trademark of Alpha Technologies.
745-847-C2-001, Rev. B (08/2013)
For more information visit www.alpha.com
United States
Bellingham, Washington Tel: 360 647 2360 Fax: 360 671 4936
Canada
Burnaby, British Columbia Tel: 604 430 1476 Fax: 604 430 8908
member of The Group
TM
Page 2 of 2
Detailed specifications for each supported enclosure are in the security bar field installation manual (search for Alpha part
number 745-847-C1-001) available at www.Alpha.com. The FPE enclosure is shown below as an example.
Figure 4, Side Bracket Installation
(Left bracket installation is mirrored)
(FPE Enclosure shown as an example))
CARRIAGE BOLT
1/4"-20 X 3/4"
FLAT WASHER 1/4" (2 PLACES)
LOCK WASHER 1/4" (2 PLACES)
NUT 1/4"-20 (2 PLACES)
ENCLOSURE DOOR
LOCK BRACKET
Figure 5, Lock Bracket Alignment and Installation
LOCK BAR
LOCK
LOCK GUARD
Figure 6, Lock Guard Installation
Figure 3, Drill Locations
Figure 2, Marking Bracket Locations
The security bar and lock bracket lock holes must line up before securing the lock
bracket to the enclosure door, see Figure 5.
NOTE:
Step1
Step 2
Step 3
Step 4