Continued – Alpha Technologies UPE-6L User Manual
Page 29
2. Installation
29
031-178-C0-001 Rev. A
2.6.4 Battery Connection
2.6 Battery Installation,
continued
Tools Needed:
Two 7/16” open end wrenches
DC Voltmeter
Torque wrench 0-100 In-Lbs
Battery Cable Kit -
For part numbers and descriptions of Cable Kits,
Please refer to the power supply Order Guide
Procedure:
For UPE-3L:
1.
Unlatch and slide the battery tray out to the stops.
2.
Install three batteries, position batteries as shown in Fig. 2-5.
3.
Wire in accordance with Fig. 2-5. Torque connections to manufacturers
recommendation. Apply corrosion inhibitor to terminals and connections.
DANGER:
Battery drawer slides may be damaged if drawer is forced into enclosure
while slide latch is engaged.
4.
Unlatch and slide the tray evenly into the enclosure.
5.
Using a DC Meter, measure the voltage at the power supply connector,
verify that the voltage is between 36 and 40.5 VDC.
6.
DO NOT connect the battery pack to the power supply at this time.
For UPE-6L:
1.
Unlatch and slide the upper battery tray out to the stops.
2.
Install three batteries, position batteries as shown in Fig 2-6.
3.
Wire in accordance with Fig. 2-6. Torque connections to manufacturers
recommendations. Apply corrosion inhibitor to terminals and connections.
DANGER:
Battery drawer slides may be damaged if drawer is forced into enclosure
while slide latch is engaged.
4.
Unlatch and slide the upper battery tray evenly into the enclosure.
5.
Unlatch and slide the lower battery tray out to the stops.
6.
Install three batteries, position batteries as shown in Fig 2-6.
7.
Wire in accordance with Fig. 2-6.
8.
Unlatch and slide the lower battery tray evenly into the enclosure.
9.
Using a DC Meter, measure the voltage at the power supply connector,
verify that the voltage is between 36 and 40.5 VDC.
10.
DO NOT connect the battery pack to the power supply at this time.