Alpha Technologies Node Power Supply User Manual
Page 18
18
031-295-B0-001 Rev. A
2.0 Installation
2.1 Pole-mounted version, continued
2.1.4 Populating the Cabinet and Turn-up
1.
Make the necessary utility connections (per Section 2.5, Connecting Utility Power) to provide
power to the enclosure.
2.
Install the power supply.
3.
Load the batteries and connect per the wiring diagram label on the enclosure door. Tighten
hardware to battery manufacturer's specifications. Do NOT connect the battery string to the
power supply at this time.
4.
Connect the SPI, tamper switch and communications module at this time. For complete
installation procedures, please see Section 2.8.
5.
Apply utility power.
6.
Connect battery string to XM Series 2 Power Supply.
7.
Switch battery breaker on.
8.
Wait for battery alarm to clear.
9.
Unit is now ready to be placed into service.