Alpha Technologies VMX Series - Manual (Page 25)

25 017-940-B0-001, Rev. A
3.0 Installation, continued
3.3 Installing the Coax Cable Connector Outputs
WARNING!
Before performing the following procedure, disconnect the power supply from line voltage
and switch the battery breaker OFF.
The VMX Standby Power Supply can be adapted to support four coax cable outputs.
Necessary Tools:
Philips Screwdriver
Procedure:
Neutral
1. Remove the two small bolts securing
the four-output connector plate.
2. Pull the connector plate clear of the
chassis and disconnect the fi ve wires.
3. Connect the wires to their appropriate
terminals on the coax cable connector.
The neutral wire mounts below the board.
4. Secure the coax cable connector plate
to the power supply using the two small
bolts. Reconnect line power and switch
the battery breaker ON.