Alpha Technologies UL LISTED - Manual (Page 9)

Step 7a
Drilling Holes & Installing Floor Anchors
Always check for rebar or underground obstructions before drilling!
Using the drill bit provided, drill holes to 1” depth at previously marked
locations (Figure 7). Clean drill holes as you go using shop vacuum with
Hepa Filter. Insert drop-in floor anchors and insure top of anchor is flush
with floor.
Drill to 1” depth
Figure 7 Figure 8
Place Barrier Walls back over the perimeter to check alignment and hole
accuracy. Using the anchor punch tool set the drop-in floor anchors into
the floor. After all components have been situated, continue to secure the
remaining Barrier Walls to the floor by tightening the floor anchor
assembly bolts, using a 7/16” socket, 110 inch pounds.
ÆRack
Page 8