Installation – American Expedition Vehicles JK Front Bumper Skid Plate User Manual
Page 3
Advertising
1
INSTALLATION
1. Install the six M8 U-nuts onto the Bumper edge (Fig 1-A) aligning with the six holes in the Bumper.
Figure 1
2. Inspect your vehicles compatibility beam (Fig 2). Depending on the model year of your vehicle,
your compatibility beam may have the square cut-outs (A), have only the round bolt holes (B), or no
attachment holes at all. If NO holes are present skip to step #4.
Figure 2
3. Install the two M10 U-nuts into the square cut-outs on the compatibility beam (Fig 1-B), aligning with
the adjacent round holes. If the square cut-outs are not present on your vehicle you may skip this
step. Continue to step #8.
A
A
B
B
A
B
A
Advertising