American Expedition Vehicles JK Hi-Lift/Pull-Pal Mount User Manual
Page 5
Advertising
4
4.
A. Remove hinge bolt from your Pull-Pal. Insert
AEV Pull-Pal roller, making sure the groove is
to the right as shown, and replace bolt.
DO NOT OVERTIGHTEN.
B. Lift pull-pal onto Hi-Lift/Pull-Pal mount, set-
ting roller into the hook on the accessory
mount frame.
C. Use locking J-bar to mark location for drilling
on your Pull-Pal. Punch the center location
then drill a 1/8 in pilot hole. Drill or ream out
to 5/16 in. Insert J-bar into hole and tighten
nut knob to secure.
C.
A.
B.
Advertising