American Expedition Vehicles JK DualSport RS Suspension 3.5/4.5 - Manual (Page 11)

9
D. Pre-assemble the second bracket as shown (Fig. 19) with the supplied bolt, washers, and free-
spinning nut.
Figure 19
E. Install this bracket in front of the stock track bar bracket on the axle and line up the small holes
with the corresponding ones on the axle bracket. Insert the remaining two 3/8”x 1.0”L bolts and
washers from the front through the brackets, add nuts and hand tighten.
F. Insert the 1/2” x 1 1/2”L bolt through the factory stabilizer tab on the side of the axle and the cor-
responding bracket hole and add the locking nut.
G. Place 9/16” x 3 1/2”L bolt through original track bar hole, both brackets, and supplied spacer tube.
H. You may now tighten all fasteners.
22 ft/lbs
40 ft/lbs
100 ft/lbs
100 ft/lbs
22 ft/lbs
Figure 20