American Expedition Vehicles AEV-Nth JK Suspension Systems - Manual (Page 6)

IJKS0100R (JK RHD Suspensions).doc Released: 12-Jan-10 page 6 of 14
8-3: JK RHD Front Trackbar Brackets viewed approximately from location of front license plate
Next, take the remaining bracket (with single right-angle bend in it), and place it over the front of
the original trackbar bracket (first remove the 9/16” bolt then reinsert though the lowermost hole). The
bent side of the bracket should be up against the stock swaybar endlink tab and the ‘quarter moon’
cutout should fit to the top-forward portion of the axle tube – and lastly the lower tab fits into the pocket
where the steering stabilizer had been mounted originally (it will be relocated). Once positioned, add
another ½” bolt through the stock endlink tab into the corresponding hole on the bracket and tighten it,
then add the nut to the 9/16” bolt in the lower (original) trackbar hole and tighten it as well. Finally,
tighten the original/stock steering damper bolt to ‘clamp’ around the lower tab.