Associated Equipment 6042 - Manual (Page 8)

8
ASSEMBLING THE CART:
1. Place lower tray (1) and upper tray (2) on flat surface. Align
the lower holes in back leg (3) with holes in lower tray (1),
fasten the back leg to lower tray with 2 each bolts (4), washers
(5) and nuts (6). Align the middle holes in back leg with holes
in upper tray and fasten with 2 each bolts (4), washers (5) and
nuts (6). Note: At this time only finger tighten the bolts and
nuts, so the frame can be easily adjusted to square later.
2. Place front leg (7) onto lower and upper trays aligning the holes
in all three parts. Attach the front leg to both trays with bolts
(4), washers (5) and nuts (6). Flip the cart over 180° and
repeat steps 1 and 2 for the right side legs.
See Figure 1.
3.
Attach the top plate (8) and handle (9) with 4 each of #10x1”
screws (10) and #10 nuts (11).
See Figure 2.
4.
Attach the B.E.S.T. control unit (12) to the top plate (8). Place
the feet (13) between top plate and control unit. Flat side of
foot is placed against top plate. Insert the #10x1 ¼” screws
(14) through top plate and feet and thread into the threaded
fasteners in the four corners of the control unit base.
See Figure 3.
5.
Tap one axle nut (15) onto one end of the axle (16) with a
rubber mallet. Slide one wheel (17) onto the axle. Push the
axle through the holes located on the bottom of the back legs.
Slide the second wheel onto the axle. Tap the second axle nut
onto the axle.
6. Press the feet inserts (18) into the bottom of the front legs.
7. Make sure the frame is square before tightening all bolts and
nut to a snug fit.
DO NOT OVER-TIGHTEN, over-tightening
can deform the legs.
8. Place the top plate/control unit assembly on the assembled
cart. Fasten the top plate to the back legs with 2 each bolts
(4), washers (5) and nuts (6). Attach the top plate to the front
legs. The top plate has two pairs of holes so the viewing angle
can be adjusted. Bolting through the top pair of holes will
mount the top plate in a flat position. The lower pair of holes
will elevate the plate at a 15° viewing angle.
See Figure 4
ASSOCIATED EQUIPMENT CORPORATION
5043 Farlin Avenue Saint Louis, Missouri 63115
Tel. (314) 385-5178 Fax. (314) 385-3254
www.associatedequip.com
Figure 3
14
13
12
1
3-1
4
5
6
7-1
Figure 1
2
Figure 2
8
9
10
11
Figure 4
4
5
6
18
15
17
16
Z4041 027-0278 Rev. 20100204