Indesit WIN 121 - Manual (Page 7)

7
GB
Function Effect Comments
Enabled with
programmes:
Rapid
Cuts the duration
of the wash cycle
by 30%.
1, 2, 3, 4,
5, 6, 7, 8
Extra Rinse
Increases the
efficiency of the
rinse.
Recommended when the appliance has a full load or with large
quantities of detergent.
1, 2, 3, 4, 5,
6, 7, 8, and
Rinse cycles.
1200-600
Reduces the
spin speed.
All
programmes
except for 11
and draining.
Personalisations
Setting the temperature
Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 6).
The temperature can be lowered, or even set to a cold wash ( ).
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.
Note: to avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by
continuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than
the set frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.
Anti-crease
This function interrupts the wash programme, and the washing is left to soak in water before the appliance is drained. It is
enabled in programmes 6 - 7 - 8 - 11 and Delicate rinse cycle.
To conclude the cycle, press the START/RESET button.
To run the draining cycle alone, set the knob to the relative symbol and press the START/RESET button.