Atec Anritsu-MA2700A - Manual (Page 2)

2 PN: 11410-00692 Rev. B MA2700A TDS
Specifications Interference Hunter™ MA2700A
Specifications
All specifications and characteristics apply to Revision 1 instruments. All published specifications are typical.
Power Consumption
Preamplifier On 0.6 Watts
Preamplifier Off 0.5 Watts
Preamplifier
Bandwidth 10 MHz to 6 GHz
Gain ≥ 8 dB: 10 MHz to 2.4 GHz
≥ 5 dB: > 2.4 GHz to 4 GHz
≥ 3 dB: > 4 GHz to 6 GHz
Electronic Compass
Power Powered from USB
Accuracy ≤ 5°
Interface USB
GPS Receiver
Satellites Tracked 12 (maximum)
GPS Locking Time Cold start: 30 s, typical, with a clear view of the sky
Warm start: 2 s, typical, with a clear view of the sky
Position Uncertainty ± 2 meter, typical
Cables
USB cable terminated with a USB Type A Female Plug, 1.5 meters
Coaxial cable with Type-N male connector, 1.5 meters
Tripod Mount
1/4 - 20 UNC x 7 mm
Electromagnetic Compatibility
European Union CE Mark, EMC Directive 2004/108/EC and Low Voltage Directive 2006/95/EC
Interference EN 61326-1
Emissions EN 55011
Immunity EN 61000-4-2/-4-3/-4-4/-4-5/-4-6/-4-11
Australia and New Zealand C-tick N274
Safety
Safety Class EN 61010-1 Class 1
Environmental
Operating Temperature –10°C to +55°C
Maximum Humidity 95 % non-condensing
Altitude 4600 meters
Shock MIL-PRF-28800F Class 2
Storage –40°C to 71°C
Size and Weight
Size 303 mm x 220 mm x 70 mm (11.9 in x 8.7 in x 2.76 in)
Weight < 1 kg (2.2 lb)
How to Use the MA2700A
Connections
• Connect an antenna to the male N-connector (inside the coupling nut).
• Connect USB cable between the MA2700A and the instrument. Connect coaxial cable between the MA2700A and the instrument's RF Input
connector.
Instrument Setup
• Confirm that the instrument has SPA module V6.00 or higher.
• Select the Interference Analysis (Option 25) mode on the instrument, then select Interference Mapping measurement.
• The instrument will detect the connected MA2700A and display the message MA2700 detected -- Device is ready to use. After GPS lock,
the instrument will use GPS data from the MA2700A.
• To manually select the MA2700A: In the Measurements menu, press Interference Mapping twice. Choose the Direction Finding submenu
then Direction Finding Antenna Selection, and select MA2700 Handheld.
Mapping
• Anritsu easyMap Tools is used to create maps that are displayed on the Anritsu instrument. The software is available from the Anritsu web site.