Atec Espec-SH Series - Manual (Page 12)

１１
ACCESSORIES
SHELVES SAFETY DEVICES
●
Load capacity (uniformly distributed load)
SH/ SU-221, 241, 261 500g
SH/ SU-641, 661 5kg
●
Number of shelves
SH/ SU-221, 241, 261 5 (Shelf pitch 35mm)
SH/ SU-641, 661 5 (Shelf pitch 50mm)
●
Shelf 1
●
Connector
2P for connecting terminal for temp & humid recorder 2 (1 for SU)
6P for connecting signal terminal 1
●
Rubber plug for cable port 2
●
Glass tube fuse 1
●
Adaptor for socket 1 (100V AC, 115V AC only)
(for SH/ SU-221, 241, 261)
●
Wet-bulb wick 1 box (SH only)
●
Humidifying tray drain hose 2m 1 (SH only)
●
Water level sensor tank drain hose 0.3m 1 (SH only)
●
Instruction manual 1
●
Warranty 1
●
Leakage breaker for power supply
●
Thermal fuse
●
Boil dry protector (SH only)
●
Short circuit protection fuse for control circuit
●
Overheat protector
●
Overcool protector
●
Air circulator temperature switch
●
Specimen power supply control terminals
●
Refrigerator overload relay
●
Inside chamber door switch
●
Upper and lower temperature & humidity limit alarms
(built inside temperature & humidity controller)
●
Burn-out detection function
(built inside temperature & humidity controller)
●
Watchdog timer
(built inside tem-perature & humidity controller)
●
Refrigerator automatic delay circuit
(built inside temperature & humidity controller)
DANGER
CAUTION
●
Do not use specimens which are explosive or inflammable, or which contain such
substances. To do so could be hazardous, as this may lead to fire or explosion.
●
Do not place corrosive materials in the chamber. If corrosive substances or
humidifying water is used, the life of the unit may be significantly shortened.
●
Do not place life forms or substances that exceed allowable heat generation.
Be sure to read the instruction manual before operation.