Atec California-Instruments-15001iX - Manual

n Single Box AC Power System.
Combines AC & DC power source, digital
scope and power analyzer in one
instrument
n DC Output Capability
Use same instrument for DC output
n 3000 VA to 15000 VA AC Power Levels
Match power source and cost to
application requirements
n Arbitrary Waveform Generator
Test products for harmonics
susceptibility
n Built-in DSP based Power Analyzer
Performs voltage and load current
analysis on all phases
n Programmable Output Impedance
Simulate real-world line conditions
n High Crest Factor Capability
Drives a wide variety of
non-linear loads
n CE Marked
Safe, reliable and consistent operation
Integrated System
The
iX Series represents a new
type of AC and DC power source that
addresses increasing demands on
test equipment to perform more
functions at a lower cost. By
combining a flexible AC power source
with a high end power analyzer, the
iX Series systems are capable of
handling applications that would
traditionally have required multiple
instruments.
The sleek integrated approach of
the
iX Series avoids the cable clutter
that is commonly found in AC test
setups. All connections are made
internally and the need for external
digital multimeters, power harmonics
analyzer and current shunts or
clamps is completely eliminated.
Using a state of the art digital
signal processor in conjunction with
precision high resolution A/D
converters, the
iX Series provides
more accuracy and resolution than
can be found in some dedicated
harmonic power analyzers. Since
many components in the
iX Series
are shared between the AC source
and the power analyzer, the total cost
of the integrated system is less than
the typical cost of a multiple unit
system.
Easy To Use Controls
The
iX Series is completely
microprocessor controlled and can be
operated from an easy to use front
panel keypad. Functions are grouped
logically and are directly accessible
from the keypad. This eliminates the
need to search through various levels
of menus and or softkeys.
A large analog control knob can
be used to quickly slew output
parameters. This knob is controlled
by a dynamic rate change algorithm
that combines the benefits of precise
control over small parameter changes
with quick sweeps through the entire
range.
Applications
With precise output regulation
and accuracy, high load drive current,
multi or single phase output mode
and built-in power analyzer
measurement capabilities,
iX Series
AC and DC source/analyzers address
all application areas for AC and DC
power testing. Additional features like
line distortion simulation (LDS),
arbitrary waveform generation and
programmable output impedance
address requirements for product
quality and regulatory compliance
testing.
Waveform Acquisition
Voltage and current waveform
data can be acquired on all three
phases and shown on the LCD
display. Applications include inrush
current measurement and load
characterization.
AC and DC Power Systems
iX Series
Power Source / Analyzer
AC and DC Power Source and
Analyzer Combination