Atec Chroma-6310A Series - Manual

programmable parameters include: slew rate,
load level, duration and conducting voltage. In
addition, up to 100 sets of system operating
status can be stored in EEPROM and recalled
instantly for automated testing applications.
Real time measurement of voltage and
current are integrated into each 6310A load
module using a 16-bit precision measurement
circuit. The user can perform on line voltage
measurements and adjustments or simulate
short circuit test using the user friendly keypad
on the front panel. Additionally, the 6310A
series offers an optional remote controller for
automated production lines.
The 6310A series has a self-diagnosis routines
to maintain instrument performance. It also
provides OP, OC, OV, OT, and reverse polarity
protection to guarantee quality and reliability
for even in the most demanding engineering
testing and ATE applications.
PROGRAMMABLE DC ELECTRONIC LOAD
MODEL 6310A SERIES
The Chroma 6310A series Programmable
DC Electronic Load is ideal for the test and
evaluation of multi-output AC/DC power
supplies, DC/DC converters, chargers and
power electronic components. It is designed
for applications in research and development,
production, and incoming inspection. The
system is configured by plugging the user
selectable load modules into the system
mainframe. The user interfaces include an
ergonomically designed user friendly keypad
on the front panel and the following computer
interfaces: RS-232, USB or GPIB.
The 6310A series offers 8 different modules
with power ratings from 100 watts to 1,200
watts, current ratings from 0.5mA to 240A,
and voltage ratings from 0.5mV to 500V. The
loads can be operated in constant current,
constant voltage, constant power and constant
resistance and may be placed in parallel for
increased current and power.
The 6310A series can simulate a wide range of
dynamic loading applications. The waveforms
Programmable
DC Electronic Load
MODEL 6310A SERIES
Key Features:
■ Max Power: 200W, 100W×2(Dual),
30W & 250W, 300W, 600W, 1200W
■
Wide range 0~500V operating voltage
■ Compatibility between 6310 and 6310A
■ Up to eight channels in one mainframe,
for testing multiple output SMPS
■
Parallel load modules up to 1200W for
high current and power applications
■
Synchronization with multiple loads
■ Flexible CC, CR, CP and CV operation
modes
■
Dynamic loading with speeds up to 20kHz
■ Fast response of 0.32mA/µs ~ 10A/µs
slew rate
■
Minimum input resistance allows the load
to sink high current at low voltages
■
Real time power supply load transient
response simulation and output
measurements
■
User programmable 100 sequences. Front
panel input status for user-friendly operation
■
High/Low limits of testing parameters to
test GO/NG
■
Digital I/O control
■ Over current protection (OCP) testing
function
■
16-bit precision voltage and current
measurement with dual-range
■
Remote sensing capability
■ Short circuit test
■ Self-test at power-on
■ Full Protection: OV, OC, OP, OT and
reverse protection
■ USB, GPIB & RS-232 interfaces
RS-232 GPIB USB