Atec Amplifier-Research-1000A225 User Manual
Page 2
Page 2 of 2
SPECIFICATIONS, MODEL 1000A225
RATED OUTPUT POWER ............................................... 1000 watts
INPUT FOR RATED OUTPUT .......................................... 1.0 milliwatt maximum
POWER OUTPUT @ 1 dB COMPRESSION ..................... 900 watts nominal
700 watts minimum
FREQUENCY RESPONSE ............................................... 10 kHz–225 MHz instantaneously
GAIN (at maximum setting) ........................................... 60 dB minimum
FLATNESS ..................................................................... ± 3.0 dB maximum
± 1.0 dB with internal leveling
GAIN ADJUSTMENT (continuous range) ......................... 20 dB minimum
INPUT IMPEDANCE ....................................................... 50 ohms, VSWR 1.5:1 maximum
OUTPUT IMPEDANCE ................................................... 50 ohms nominal
MISMATCH TOLERANCE ............................................... 100% rated power without foldback up to 6.0:1 mismatch above which may
limit to 500 watts reflected power.
MODULATION CAPABILITY ........................................... Will faithfully reproduce AM, FM or Pulse modulation appearing on the input
signal.
HARMONIC DISTORTION ............................................. Minus 20 dBc maximum at 750 watts
THIRD ORDER INTERCEPT POINT .................................. 68 dBm typical
RF POWER DISPLAY ...................................................... 0–2000 watts full scale
RF RISE/FALL TIME ........................................................ 10 nanoseconds maximum
PRIMARY POWER .......................................................... 187–264 VAC
47–63 Hz, single phase
5,000 watts maximum at .95 P.F. typical
CONNECTORS
RF
Input
................................................................. See Model Configurations
RF Output .............................................................. See Model Configurations
Forward RF Sample ................................................ Type BNC female on front panel
Reverse RF Sample ................................................. Type BNC female on front panel
Remote Control ...................................................... 24 pin female GPIB/IEEE-488, 9-pin RS-232 and USB connectors on rear panel
Remote Control (Fiber Optic) .................................. ST connector. Tx and Rx RS-232.
Safety
Interlock
....................................................... 15 pin female Type D on rear panel
IEEE-488 (GPIB) INTERFACE & RS-232 ........................... Allows control of all amplifier functions and monitoring of all status indications.
COOLING .................................................................... Forced air (self contained fans), internal self-contained liquid
WEIGHT (maximum) ..................................................... 127 kg (280 lb)
SIZE (W x H x D) ............................................................ 56.1 x 109.2 x 88.9 cm (22.1 x 43.0 x 35.0 in)
MODEL CONFIGURATIONS
Model Number
RF Input RF
Output
1000A225
N female, rear panel
7-16 DIN female rear panel
1000A225M1
N female, front panel
7-16 DIN female front panel