Atec Agilent-N5173B - Manual (Page 9)

9
Broadband noise 1 () = measured
100 MHz (–143 dBc/Hz)
500 MHz (–155 dBc/Hz )
1 GHz (–163 dBc/Hz )
10 GHz (–150 dBc/Hz)
20 GHz (–143 dBc/Hz)
40 GHz (–135 dBc/Hz)
Residual FM (CW mode, rms) See frequency band table for N value
0.3 to 3 kHz bandwidth < N* 0.5 Hz (meas)
0.05 to 15 kHz bandwidth < N* 3 Hz (meas)
Residual AM (CW mode, +10 dBm, 0.3 kHz to 3 kHz bandwidth, rms)
< 2 GHz < 0.01% (meas)
Harmonics [CW mode] 2 () = typical
Range CW mode at +10 dBm CW mode at +20 dBm 3
9 kHz to 200 MHz < –48 dBc (–54) < –38 dBc (–43)
> 200 MHz to 2 GHz < –33 dBc (–40) < –25 dBc (–31)
> 2 to 20 GHz < –55 dBc (–65) < –50 dBc (–55)
1. CW mode at +10 dBm for offsets > 10 MHz. In high signal to noise ratio mode (optimize S/N).
2. Specifications apply from +15 to +35 °C and are nominal for harmonics beyond specified frequency range.
3. Or maximum specified output power, whichever is lower.