Atec Ideal-LANTEK7 - Manual

LANTEK ® 7 LAN Cable Certifier
Certifying these higher
performance systems has
required a combination of
cable testers and network
analyzers. Now you can certify
these systems up to 750 MHz
with LANTEK 7, simplifying the task
while reducing costs.
■ First cable tester fully
compliant with emerging
Category 7/ISO F standards,
with a frequency range up
to 750 MHz
■ Full Category 7/ISO F
AutoTest, with graphs in
approximately 35 seconds
■ Advanced link adapter
method provides more
versatility and reduces cost
of ownership
■ Built in TDR ready for
copper and fiber
■ First fiber accessory for a
copper tester that traces
fiber runs, displays distance
to and magnitude of events
■ Display unit comes with
1/4 VGA color screen,
remote unit comes with
two-line black and white
LCD display
■ Serial and USB ports for
uploading tests and
upgrading firmware
■ Two full-function PCMCIA
slots accept compact
flash memory and
provide for future
capabilities
LANTEK 7 is the first LAN cable tester capable
of certifying installations up to 750 MHz,
exceeding draft Category 7/ISO F specifica-
tions. Certifying these installations has
required a combination of cable testers and
network analyzers. Now you can certify these
systems up to 750 MHz simplifying the task
while reducing costs.
LANTEK 7 utilizes an advanced link adapter
method to reduce cost of ownership.
LANTEK 7 comes with a pair of Category 7/
ISO F channel adapters. These channel
adapters fit into the case of the unit and are
locked in place. This creates a stable and
repeatable testing platform while eliminating
bulky adapters extending beyond the end of
the unit. By simply plugging in a Category 7/
ISO F reference patch cord to the channel
adapter, you can now perform Category 7/ISO F
permanent link testing. Should the plug ever
wear out the patch cord is replaced rather
than the entire assembly reducing lifetime
cost of ownership.
Among the LANTEK 7 accessories are the
the industry’s most advanced fiber options,
FIBERTEK and TRACETEK. FIBERTEK
enables loss, length, bi-directional testing
over two fibers, and talkset over fiber capa-
bilities for 850 and 1300 nm Multimode and
1310 and 1550 nm Singlemode fiber.
TRACETEK is the first fiber accessory
for a copper tester that will trace
a fiber run, locate distance to
events along the fiber, and
measure the magnitude
of the event. This capa-
bility can eliminate the
need for a more costly
OTDR in campus
network environments.
LANTEK 7 Data.11/01 12/17/01 1:25 PM Page 1