Atec Mitutoyo-SJ-310 - Manual (Page 9)

9
Setting attachments
Drive unit, Display unit
(Note: Not available for the transverse tracing drive unit)
Dimensions: Display Unit and Drive Unit
Nosepiece for flat surfaces
Extension rod 50 mm
No.12AAA210
Support feet set
No.12AAA216
Detector side
Vertical positioning
adapter
No.12AAA219
Magnetic stand
adapter
No.12AAA217
• SJ-310/310R standard accessories
• Not available for the transverse
tracing drive unit.
Nosepiece for flat surface
No.12AAA217
Nosepiece for cylindrical surfaces
No.12AAA218
• SJ-310/310R standard accessories
• Not available for the transverse
tracing drive unit.
• ø30mm or smaller workpiece.
V-type adapter
No.12AAE644
• SJ-310S standard accessories
• Dedicated to the transverse tracing
drive unit.
Point-contact adapter
No.12AAE643
• SJ-310S standard accessories
• Dedicated to the transverse
tracing drive unit.
Extension rod (50 mm)
• Not available for the transverse
tracing drive unit.
Extension cable (1 m)
No.12BAA303
• For connecting calculation display unit and drive unit.
Support feet set
No.12AAA216
• SJ-310 standard
accessory
• Not attachable to
the detector side
of the transverse
tracing drive unit.
Vertical positioning adapter
No.12AAA219
• Not available for the
transverse tracing drive unit
Magnetic stand adapter
No.12AAA221(ø8mm)
No.12AAA220(ø9.5mm)
Height gage adapter
No.12AAA222(9x9mm)
No.12AAA233(1/4inx1/2in)
Nosepiece for
cylindrical surface
No.12AAA218
Height gage adapter
72mm
7.7mm
Enhances measurement efficiency by facilitating the measurement setup of multiple workpieces of the same type and of the hard-to-access
sections of a workpiece.
V-type for measuring axially Slider type Inside diameter type
No.178-033
The V-width is adjustable
to the cylindrical workpiece
diameter, facilitating axial
measurement of a wide
range workpiece sizes.
• Adjustable range:
ø 5 ~ 150 mm
No.178-035
Greatly facilitates measurement
of internal wall surfaces of, for
example, a cylinder block.
• Applicable diameter:
ш 75 ~ ш 95 mm
• Accessible depth:
30 ~ 135 mm
No.178-034
This attachment is ideal for measuring
a flat area of a workpiece that has
an indentation or step that makes it
difficult to attach the drive unit. You
can further improve the ease of use
by using this attachment with the
magnetic installation base (option:
No. 12AAA910).