Atec Tenney-T-Shock-JR - Manual (Page 4)

Tenney Environmental
Three-zone horizontal chamber.
Available in horizontal and vertical configurations.
Standar Standar Standar Standar Standard F d F d F d F d Featur eatur eatur eatur eatures es es es es
at a Glance: at a Glance: at a Glance: at a Glance: at a Glance:
Chambers offered in three configurations: Two-Zone
Operation, Three-Zone Operation, and Dual Load Operation
Most systems available in either horizontal or
vertical orientation
Vapor tight interior made of 100% stainless steel
Non-settling, asbestos-free insulation
Proprietary VersaTenn control system
Control tolerance of ±1ºC
Platinum RTD temperature sensor
Low mass nichrome, open wire heating system
NEC wiring compliance
Double silicon gaskets on doors
Transport system includes large wire mesh
stainless steel product basket
Water-cooled cascade refrigeration system;
T-Shock Jr. uses air-cooled cascade system
IEEE/488 interface
LinkTenn software for Windows that permits
your computer to control up to 10 chambers
RS422, 423, or IEEE/485 interface assemblies
Viewing window, thermally insulated and
heated (no manual wiper required)
Interior lighting
Automatic CO
2
or LN
2
cooling boost system. Note:
standard on T-Shock Jr.
GN
2
purge system, with each chamber having
an independent shut-off valve
Recording instruments
Redundant thermal protection and alarm system
Alternate power supply wiring
Chamber cart with casters
Chamber casters
Recording instruments
Additional stainless steel product baskets
Various voltage inputs
50 Hz operation
Moving cable access port
Auxiliary temperature sensors
Guaranteed specimen exposure time system
Air cooled refrigeration system.
Note: standard on T-Shock Jr.
Noise reduction insulation
Remote refrigeration package
In line with our policy of continual product improvement, Tenney
Environmental reserves the right to incorporate and use material to
conform to the latest design of our products in keeping with the
specifications of this equipment. Our standard equipment uses a dewpoint
coil (low surface temperature) to obtain low relative humidities. This
approach can lead to time-limited performance at low relative humidities.
Please discuss specific test and cycling requirements with our sales
department.
121-AP0599
Options: Options: Options: Options: Options:
A = All thermal shock units
B = All thermal shock units, excluding T-Shock Jr.
C = T-Shock Jr. only
A
A
A
B
B
A
A
A
A
A
C
B
A
A
A
A
A
A
A
A
B
B
IS09001
PJR Cert. No. 99-085
Quick Facts Quick Facts
Tenney Environmental
Manufacturing:
2121 Reach Road
Williamsport, PA 17701
570-326-1770
Fax: 570-326-7304
E-mail:
www.tenney.com
[email protected]