Brickcom WFB-100Ap - Manual (Page 8)

Confidential © Brickcom Corporation, All Rights Reserved.
WWW.BRICKCOM.COM | EXPERT IN IP SURVEIL LANCE
• Step 1: Power on the DWRT-600N and the WFB-100Ap. Wait 1 minute for both
devices to be up and running.
• Step 2: Press the WPS button of the DWRT-600N. The WPS LED will be blinking.
• Step 3: Press the WPS button of the WFB-100Ap. The WPS LED will be blinking.
• Step 4: When the WPS LED of the WFB-100Ap stops blinking and becomes ON, WPS is
successfully done. The process usually takes less than 1 minute. The
WPS Camera LED
of the DWRT-600N will remain ON.
• Step 5: If you have more than 1 camera, repeat step 2~4.
• The wireless connection is encrypted and secure.
Set Up Wi-Fi Connection Using WPS
Blinking: WPS is running
OFF: WPS is not running
ON: Brickcom IP camera is connected
WPS Button
WPS LED