AmeriHome BS2205SET Bar Stools - Manual (Page 2)

ASSEMBLY INSTRUCTION
For proper assembly, follow the instructions below.
Insert the thinner end of the Support Cylinder into the center
hole of the Base, and press down FIRMLY.
Screw the Foot Rest onto the bottom of the Seat
Guide the assembled Support Cylinder and Base into the
hole on the bottom of the Seat and firmly press down on
the Support Column.
To raise and lower the seat, grasp the Handle and pull upward without applying any weight on the
seat. To lower, raise the handle upward by sitting on the seat.
To disassemble, turn the stool upside down and hit the clip in the center of the
bottom of the Base with a hammer to disengage the locking mechanism. Then,
turn the stool right side up, and lift the Seat upward, pulling the Seat assembly
off of the Base.
To remove the Seat from the Support Cylinder, turn the stool upside down,
and gently strike the edge of the Seat where it meets the Support Cylinder.