AmeriHome BS2304С Bar Stool - Manual (Page 2)

A Black Cap protects the
hydraulic mechanism on
the Support Cylinder.
Place the Foot Cap
over the Footrest.
Remove the Black Cap and
discard it before assembly.
The Orange hydraulic
button will become visible.
Insert the Support Cylinder
into the center of the Seat
Plate
Insert the Support
Cylinder into the center
hole of the Footrest
Press down firmly
on seat to secure
into base.
ASSEMBLY INSTRUCTION
To raise and lower the Seat, grasp the Handle and pull upward without applying any weight on the
Seat. To lower, raise the Handle upward by sitting on the Seat.
To disassemble, turn the stool upside
down, and hit the metal clip on the center
of the bottom of the Footrest with a rubber
mallet to disengage the locking
mechanism. Then, turn the stool right side
up, and lift the Seat upward, pulling the
Seat Assembly off of the Footrest.
To separate the Support Cylinder from the Seat, gently strike the Seat Plate with a
rubber mallet until the Seat and Support Cylinder have separated.
MODEL B2304C ROLLING CASTER WHEEL ASSEMBLY
If you have Model B2304C, remove the Staionary Feet by unscrewing each one,
and replace them with the Caster Wheels.
Use an allen wrench to attach the
Seat Plate to the underside of the
Seat with the provided Screws.
Metal Clip