BARSKA Swat Re-zero - Manual

WARNING: Turning the screw too tight or too loose can cause damage to the scope
Re-Zeroing Windage and Elevation Turret Scales
Re-zeroing scale back to zero is optional and should only be done after zeroing in your scope
Loosen the lockable bell at the base of the
turret by turning it clockwise Remove screw by turning counter clockwise
Note: Keep screw in a safe place
Pull the turret cap gently up to disconnect it
from the drum inside
Turn the cap to reset the scale to zero Place the screw back in place, hold the cap
and turn screw clockwise to lock the cap
© 2011 BARSKA ® | La Verne, CA 91750 BC153
SWAT
Your scale is now re-zeroed
1 2 3
4 5 6
1-1½ turn of the
allen wrench
www.bar ska.com
1-1½ turn of the
allen wrench