BARSKA BE11642 Elite Edition Metal Detector - Manual (Page 5)

5
2. Unscrew the knob on the search coil and remove the knob connector.
Insert the stem and align the holes on the search coil bracket and the stem.
Push the connector through the holes and tighten the knob.
3. Wind the search coil cable around the stem. Leave enough slack in the
cable. Insert the search coil cable plug into the five pin jack on the
front control box’s housing.
4. Turn the stem’s lock nut clockwise until it loosens. Lengthen or shorten so
when you stand upright with the detector in your hand, the search coil is
level with and about 1/2 to 2 inches above the ground with your arm
relaxed at your side. Turn the stem’s lock nut counter-clockwise to lock it in
place.
Caution:
• DO NOT force the plug or you could damage it. The search coil’s plug
fits into the connector only one way.
• DO NOT over tighten the search coil or use tools such as pliers to
tighten it.
• DO NOT disassemble the stem lock nut. In case you disassemble it
carelessly, place the washer on the top of the stem connected with
the handle with the small
head of the washer
upwards. Then hitch the
stem lock nut on the
washer then tighten it to
lock it in place.
INSTALLING THE BATTERIES
Cautions:
• Use only fresh alkaline batteries of required size.
• Do not mix the old and new batteries or different types of batteries.
Small head