BatteryMINDer 24041 User Manual
Page 4
 
BatteryMINDer
®
Models 12248 & 24041
Rev. C-082713
Page 4
P/N VDC12248/24041-MNL
or otherwise damaged in any way; call
VDC Electronics Tech
Support Dept. 800.379.5579 x6 (ET) for advice.
9. Do not disassemble charger; call
VDC Electronics Tech Support
Dept. 800.379.5579 x6 (ET) for advice when service or repair is 
required. Incorrect reassembly may result in a risk of electric shock 
or fire. 
10. To reduce risk of electric shock, unplug charger from outlet before
attempting any maintenance or cleaning. Turning off controls will not 
reduce this risk. 
11. WARNING – RISK OF EXPLOSIVE GASES
a. WORKING IN VICINITY OF A LEAD-ACID BATTERY IS
DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES 
DURING NORMAL BATTERY OPERATION. FOR THIS 
REASON, IT IS OF UTMOST IMPORTANCE THAT YOU 
FOLLOW THE INSTRUCTIONS EACH TIME YOU USE THE 
CHARGER. 
b. To reduce risk of battery explosion, follow these instructions and
those published by manufacturer of any equipment you intend to 
use in vicinity of battery. Review cautionary marking on these 
products and on engine.
12. PERSONAL PRECAUTIONS
a. Consider having someone close enough by to come to your aid
when you work near a lead-acid battery.
b. Have plenty of fresh water and soap nearby in case battery acid
contacts skin, clothing, or eyes.
c. Wear complete eye protection and clothing protection. Avoid
touching eyes while working near battery.
d. If battery acid contacts skin or clothing, wash immediately with
soap and water. If acid enters eye, immediately flood eye with 
running cold water for at least 10 minutes and get medical 
attention immediately. 
e. NEVER smoke or allow a spark or flame in vicinity of battery or
engine.
f.
Be extra cautious to reduce risk of dropping a metal tool onto 
battery. It might spark or short-circuit battery or other electrical 
part that may cause explosion. 
g. Remove personal metal items such as rings, bracelets, necklaces,
and watches when working with a lead-acid battery. A lead-acid 
battery can produce a short-circuit current high enough to weld a 
ring or the like to metal, causing a severe burn.