Camco D-Power 1 - Manual (Page 12)

D - P O W E R
S E R I E S
442,0 mm
240,7 mm 249,7 mm
224,7 mm
465,0 mm
76,2 mm 88,1 mm
10,5 mm
7,5 mm
76,2 mm
USER MANUAL
D-POWER 05/1
P.11
3.1 Mounting
Use four screws and washers when mounting the amplifier to the front
rack rails.
3.2 Cooling
Under normal operation of the power amp, overheating should never be a
problem. The amplifier uses passive cooling through it's internal heatsinks.
Only when the temperature rises above approx. 60°C, the fan is switched
on. When the fan is running, the air is taken in from the front and out
through the back. It is essential that while the amplifier is running the air is
able to circulate around it freely.
The efficiency of the cooling will depend on the immediate environment
(e.g. an enclosed rack, direct sunlight). If the amp is installed in a case,
the open area at the back of the case must be at least 140 cm². This area
should be in line with the amplifier.
If this cannot be achieved a forced ventilation system has to be used.
3 INST
ALLA
TION