Daymak Voyager - Manual (Page 6)

www.daymak.com
Page 6
The Voyager Electric Bicycle User’s Guide
TPS Training Bulletin
Holding the Handlebars
As with a normal bicycle or gas scooter, place your fingers over the brake levers, using the palms
of your hand and your thumbs to wrap around and under the handlegrips. Doing this allows you to
activate the brakes easily, by squeezing your hand, in case you have to stop quickly. This is the
safe way to control your electric bicycle.
Turning your E-Bike On and Off
To turn on your e-bike, insert the key into the “ignition”, located just below the dash board, and
turn the key to the right. When your e-bike is activated, the power indicator will light and the
battery charge indicator will jump, showing you how much power your e-bike has.
To turn off the e-bike, simply turn the key to the left, and remove the key.
Warning
When you activate the e-bike, the electrical system becomes live. Do not try to affect changes to
the E-Bike (such as removing the battery or repairing electrical components) while the E-Bike is
activated. Turn the E-Bike off and remove the key before you attempt to access any of the
electrical components. Also, the battery carries a significant electric charge and can injure
people if not treated properly and with respect.
Accelerating and Decelerating
The throttle is found on the right-side hand grip on the handlebars. Turn the grip forward (away
from you) to accelerate. To decelerate, release the grip (turn it towards you). Don’t over-rotate the
accelerator, as this could damage the battery and electrical components.
Warning
Do not activate the accelerator until you are seated on the bicycle and are ready to accelerate.
The e-bike can easily escape from your control, possibly injuring you or others, and the e-bike
may be damaged by being dropped.